Crash Journal

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Didn't get around to working on the doors. Home Depot lumber prices were insulting considering the pathetic quality of the boards. I left without buying anything. For a change Lowes has better prices, less than half, but I haven't made the trip to see what it looks like. There are a couple of lumber yards that would sell me better boards for a lot less, but the closest one is 90 minutes away. I will figure something out next week.

I chopped all the autos this morning. There were 5 without seeds, and two with seeds. I didn't think I would get much bud from the 5, but it looks like about 2 ounces. The two with seeds I just rough trimmed and set aside to dry, so the seeds will be easier to collect.

The two Supafreaks are now on large auto water trays. I need to up pot them both to 5 or 7 gallon pots, but for now I can at least ignore them for up to a week while the wicks feed them from the trays. I also need to make some clones, especially of the one that might be a male. No reason to up pot it if it is.

1737930247789.png
 
They seem to still be growing, so I must be doing something right, The one I started from a seed lost a couple of branches for clones yesterday. I can't even tell where I took them. Using the Oxyclone this time. It tends to work better when the temperatures are low. I might put a couple from each in solo cups as well.

1738106327972.gif
 
It's been a busy week at work, so I haven't had time or ambition to work on the attic. I have plenty of 2X4's laying around, so my current plan is to square them up and make 1/2X2 slices for the door frames, and something similar for the doors. With luck the only cost will be the hinges, though I might decide to use some 1/8 hardboard over the 2X4 slices on the doors.

The Supafreak I grew from a seed is female. I'm stunned, since I never had one show before it was flipped. So they both get bigger pots this weekend. Should have some clones rooting soon as well.

1738277757315.gif
 
It's been a busy week at work, so I haven't had time or ambition to work on the attic. I have plenty of 2X4's laying around, so my current plan is to square them up and make 1/2X2 slices for the door frames, and something similar for the doors. With luck the only cost will be the hinges, though I might decide to use some 1/8 hardboard over the 2X4 slices on the doors.

The Supafreak I grew from a seed is female. I'm stunned, since I never had one show before it was flipped. So they both get bigger pots this weekend. Should have some clones rooting soon as well.

View attachment 369689
 

Latest posts

Back
Top