CrashMagnet's latest activity

I have done it a lot. I have no doubt it will work.

It turned out to be a 1/2" piece of plywood, but it worked really well. I also put six screws halfway into the board before I picked it...

The 2x4 is a good idea. You could run an 8ft 2x4 and hang 2 boards before moving the board.

I'm definitely going to try this. I was thinking of all sorts of complicated holding rigs, but that's so simple it has to work...

I would temporarily screw a 2x4 in the area where I made the red line. Set the bottom of my sheet rock on the 2x4, screw the top, work...

They're 16" centers. The ceiling is 60" wide which if I went cross ways I would have 36" ends left over. The sides are 42", so I...

The reason I asked is maybe if you ran your rock the other direction on the ceiling you wouldn't have that butt joint you are talking...

Man, ya'll make it so hard....I have to scroll back and forth fifty times to decide....🤣

GMO jojo auto Fem, still working on the photography skills. 😁

Ran into a small snag hanging sheet rock. The slanted sections are 65" tall which leaves me short sections that I can use on the...

Even if I gather all the tools I need, one of them will be missing when I go to pick it up. Then I have to wander all over the building...

Ha ha ha, it seems like every every project I start, I spend half of the first day looking for, and gathering up the proper tools.

Heater removed. Now humidifier has also been removed due to increased humidity from the CO² Generator. 6 hours till I know if we need to...

No need for fuzzy logic since we can't micro dose with a generator